Wiring and Mounting a HUUM UKU Sauna Controller

Measurements stated

• 4-wire connection

Key facts

• The HUUM UKU controller uses four crimped red wire contacts connected to numbered terminals 1 through 4.
• Removing the central dial knob on the HUUM UKU panel exposes two mounting screw holes.

Questions this answers

• How are the four wires connected inside a HUUM UKU sauna controller?
• Where are the mounting screw holes located on a HUUM UKU control panel?
• Where should a HUUM UKU Wi-Fi controller be mounted on an outdoor barrel sauna?

Transcript

So for the HUUM UKU controller, it comes with four red contacts, so you have to strip this grey wire, and then it reveals four inside. And those correspond to what you put into the control unit on the left there. And you need to strip those each individual wire and get it into these contacts with a crimper. And then, you can use a small screwdriver, this one's pretty good from Klein Tools, to do the last bit. And you'll see this is the controller, and I popped the button off. So let's go here. So all you do to remove the button, because it normally looks like has this little cover on it, and you just gently pull it back, and it'll show you where the two mount screws are. And you'll use those to place this. And what we're doing here is we're going to actually place this behind since the client has Wi-Fi control on their phone, this won't need to be super accessible. So we're going to put it behind right by the control box. We're going to put it in this crevice to keep it out of the weather. And then we'll clean up the excess cord with, what's it called, cable clamps.